Aluminum alloy doors and Windows have aging push-pull is not smooth, wear effective treatment methods
Aluminum alloy doors and Windows have aging, push-pull is not smooth, wear effective treatment methods
Aluminum alloy doors and Windows with its stable quality and high cost performance are welcomed by people,
in the current residential is widely used, in the actual installation and construction, if you do not pay attention to
some details, often leave hidden dangers for future use, now ask experts to teach you to put a good installation.
First: Common problems of window screens
Plastic steel window screens and aluminum alloy window screens are easier to screen aging, invisible window screens
are too dusty and oily to do routine cleaning, but can only be replaced with new window screens. Invisible window screens
often appear not back, yarn mesh slot, accessories aging and other problems, many because the manufacturer does not exist,
and the parts of different models can not be repaired, can only be customized. Third: flat open upper hanging window accessories
wear
Fittings wear is the most common problem of flat hanging Windows. If the switch is too hard to cause the handle inside the gear and break,
break the rotating handle feel very light, because there is no rotating gear can not move the transmitter, so it can not smoothly switch the window,
this situation only need to change a handle on the line, if it is able to flat open can not be suspended or suspended window traction broken then you
need to replace the whole set of flat open hanging window all accessories. Fourth: door and window penetration
Before installation, check whether the doors and Windows are qualified, whether the combination between the window frame and the window sash is tight,
and whether the installation of the window sash seal is qualified
Door and window frame and wall shall not be caulked with cement mortar, should be elastic connection, sealed with sealant caulking, no gaps.
There is a gap of more than 50 mm between the window frame and the hole, so that the windowsill can be a running slope.
The bottom of the outer frame and the track root should be drilled drainage holes.
Hardware accessories related to the door and window of the switch feel, flexibility, safety, service life, when you must ask more and try.
Good hardware should be polished,polished, electroplating treatment, surface treatment is more fine, acid and alkali resistance, corrosion resistance, smooth surface,
no burr pitting, easy to clean. Poor hardware process is simple, easy to scratch paint off, easy to wear. Fifth: the problem of aging of the seal
Contact Email： dora@fiplus.com
